This is how your MTF should look when removing it from the packaging.
The following steps will show you how to adjust it into the correct configuration.
Installation of the Miracle Toilet Faucet (MTF) is a simple 15 minute process requiring minimal tools, specifically designed for the homeowner to DIY (Do It Yourself.)
Please read the step by step instructions in full before you begin.
What you need to have before you begin:
With the toilet lid up, slowly turn the MTF on. Caution: If you turn it to the full vertical position, you will shoot a stream of water up and out of the bowl or in your face. With the water running, check for leaks.
Turn off your MTF, sit down and be refreshed!
Close valve handle to the horizontal position. Turn the water supply hose valve on and check that all the joints are tight and not leaking.
Move the black handle to the vertical position. Note: Water should not be on yet. Tighten the nut clockwise (right). Be careful not to over tighten.
It is now time to make your final adjustment and alignment. The joint by the valve (black handle) can slide in/out and the joints at the elbow swivel(held with left hand in the photo.)
When you have the nozzle in the back and center of the bowl it is time to tighten the nut near the valve.
Next attach your water supply hose to the brass threads at the bottom of the MTF, tighten snugly by hand.
Now screw on the white plastic nut attached to your MTF to the tank connection and snugly tighten by hand.
When loose, unscrew by hand and pull away from the tank. Note: A small amount of water will remain in the water supply hose. Drain it into the small bowl.
Make sure the rubber bushing is still in good shape. If the toilet has been there a long time, a new one might be a good idea.
This may need a bit of loosening with the pliers or vice grips.
Loosen the nut on the bottom of the water intake for your tank.
Place your small bowl directly under the connection of the toilet to the water supply hose, to catch drips. Flush the toilet once or twice to make sure the tank is empty and NOT refilling.
The nozzle should be in the center back of the toilet bowl.
The MTF is now in the correct position but the line to the toilet has only been turned off, not undone. Having the MTF in the correct position will make it easier to install.
Next, put the MTF in the correct position. Thread the nozzle under the back of the seat. If it is too tight, you might need to open the lid and seat to slide it in.
Turn off your water supply to the tank.
First, swivel the parts at the joints to match the photo. This is the shape the MTF needs to be in to attach to your toilet.